Whirlpool Duet Dryer Won T Start Just Clicks. Display responds normally, just hear a distinct click when you start the unit. The washing machine does not work because the cover switch is defective.
If you try to touch the screen and only a part of it lights up or is. Reassembled the dryer and works fine. The first easy fix on the list is the start switch.
The First Easy Fix On The List Is The Start Switch.
If your dryer just clicks and will not start, a blown thermal fuse is often the problem. When the deck is open the lid switch will not allow the engine to operate. Dryer door not latching shut.
If You Try To Touch The Screen And Only A Part Of It Lights Up Or Is.
Squeeze the switch wiring mounting tab with pliers. Unplug the dryer and remove the front panel. Detach the switch’s wiring connector from the dryer’s wiring.
To Test This, You Will Need To Press The Start Switch.
If your dryer just clicks and will not start, a blown thermal fuse is often the problem. Remove the screws on the rear of the control panel to release it. Pull the new switch’s actuator lever through the hole and reattach all screws.
Have A 7 Year Old Whirlpool Duet Dryer Model Gew9250Pw0 That Would Not Start.
I turned off power to try and reset, but no go. Unhook the control panel tabs from the top, lift the top, and remove. The blinking light could be a side effect of a dysfunctional door switch.
Is The Door Switch Working Properly?
You would need to take off the lower front access panel under your door then take off the duct assembly45 by removing the two 11 screws as shown in your parts diagram. When the deck is open, the lid switch will not allow the engine to operate. Whirlpool duet dryer clicks, but does not turn on (dryer repair) by marip 6/22/2015 8:48:05 am (utc) new topic.